dal manuale sembrerebbe facile

per quanto riguarda tutti i dati dell'osservatorio devi andare sotto "settings" nel menu 2:
Allegato:
untitled.JPG [ 25.02 KiB | Osservato 1099 volte ]
per quanto riguarda, invece, l'allineamento alle stelle devi andare nel menu 1, e poi su "Objects", vedi qua:
The object function lets you make a Sync to any objects / coordinates you like or point the
instrument to it by Goto....After input of the coordinates and Save the display will look like this. Use S for a Sync onto the
coordinates or M to point there by Goto. The function will be shown by a confirmation, if you choose
Goto the mount will start to move.dovrebbe essere abbastanza facile, almeno su carta cosi' sembra

(non conosco direttamente il photo ma non sembra troppo diverso dagli altri!)
dell'allineamento assistito non ne ho proprio letto nulla
sull'ultima domanda c'è un warinig all'inizio del manuale:
Important!!: in case you intend to run the controller with a voltage more than 14.5 Volt you must remove the link between pin 3 and pin 4 in the plug of the power supply cable.intanto io ieri sera ho provato il mio e semra avere qualche problema
